Справочник Пользователя для Samsung SRP-500
19
Transmission
2-7
2-8
2400 baud
ON
ON
4800 baud
OFF
ON
9600 baud
OFF
OFF
19200 baud
ON
OFF
*1) : It may use in dark area. (like a restaurant). But printing speed to be slow down.
*2) : Enalbe = Automatically print NV bit image #1 after cutting.
*3) : EPSON Kitchen Printer mode : A alarm is generated by printer after auto-cutting
*2) : Enalbe = Automatically print NV bit image #1 after cutting.
*3) : EPSON Kitchen Printer mode : A alarm is generated by printer after auto-cutting
and in paper-end error. (It needs buzzer accessory)
Notice
Changes in DIP switch settings are recognized only when the printer
power is turned on or when the printer is reset by using the interface. If the
DIP switch setting is changed after the printer power is turned on, the
change does not take effect until the printer is turned on again or is reset.
power is turned on or when the printer is reset by using the interface. If the
DIP switch setting is changed after the printer power is turned on, the
change does not take effect until the printer is turned on again or is reset.
20
3-2. Changing the DIP switch setting
If you need to change settings, follow the steps below to make your changes.
CAUTION
Turn off the printer before removing the DIP switch cover to prevent an
electric short, which can damage the printer.
electric short, which can damage the printer.
1) Make sure the printer is turned off.
2) Remove the screw from the DIP switch cover.
2) Remove the screw from the DIP switch cover.
Then take off the DIP switch cover, which is shown in the illustration
below.
below.
3) Set the switches using a pointed tool, such as tweezers or a small
screwdriver.
4) Replace the DIP switch cover. Then secure it with the screw.
* The new settings take effect when you turn on the printer.