Справочник Пользователя для KYOCERA 2020D
Using the Operation Panel
7-79
3
Once you enter the correct ID and password, the Admin (change)
screen appears. (E.g.: Where the administrator ID is
screen appears. (E.g.: Where the administrator ID is
00000001)
Each time you press
U or V, the following settings to be changed
appear in succession.
•
Change ID
•
Change Password
4
Press
[OK] again. The administrator ID and password are
confirmed.
5
Press
[MENU]. The display returns to Ready.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1
In step 3 in Password (Administrator Password input) above, press
U or V while the Admin (Change) screen is displayed until
>Change ID appears. (E.g.: Where the administrator ID is 001)
U or V while the Admin (Change) screen is displayed until
>Change ID appears. (E.g.: Where the administrator ID is 001)
2
When you press
[OK], a blinking cursor (_) appears.
3
Press
U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use
Y and Z to move
the cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
numbers.
4
Press
[OK]. A confirmation screen appears. (E.g.: Where the
administrator ID is changed to
002)
5
Press
[OK]. The new administrator ID is confirmed.
6
Press
[MENU]. The display returns to Ready.
Change Password (Administrator Password change)
You can use this to change the administrator password.
1
In step 3 in Password (Administrator Password input) above, press
U or V while the Admin (Change) screen is displayed until
>Change Password appears.
U or V while the Admin (Change) screen is displayed until
>Change Password appears.
2
Press
[OK]. A blinking cursor (_) appears.
3
Press
U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the password to be changed. Use
Y and Z to
move the cursor right and left. Enter a password consisting of
between 0 and 16 numbers.
between 0 and 16 numbers.
4
Press
[OK]. A confirmation screen appears. (E.g.: Where the
administrator password is changed to
010)
Note
If a change is required, refer to the procedures in
>Change ID
00000001
00000001
>Change ID
001
001
>Change ID
_
_
OK?
002
002
IMPORTANT
The administrator password is not displayed.
>Change Password
****************
****************
>Change Password
_
_
OK?
010
010