Справочник Пользователя для HP (Hewlett-Packard) 10000s

This section describes how to control the printer's heaters used for drying the printed media.

The heater's front panel is located on the front of the printer, on the left-hand side. The heater front panel
displays the settings for the Front, Print, and Rear heaters. It can also be used to control the temperature
settings.

The display screen, at the top of the panel, shows the target temperature and the current temperature
of each heater.

The three 

On/Off 

switches turn the three heaters on or off. The three pairs of   or   keys can be used

to raise or lower the target temperatures of the respective heaters.

On the heater front panel press the 

On/Off 

key, and the   and   keys at the same time to enter the

parameter setup mode.

Select a setup parameter using the   and   keys on the heater front panel and press the 

On/Off 

 key

on the heater front panel to modify the setup item displayed.

Use the   and   keys to select the value and press the 

On/Off

 key to confirm.

If you have selected an incorrect setup value, you can press the 

On/Off 

key again

to cancel the setting and repeat from step 2.

12

Chapter 1   Introduction

ENWW