Справочник Пользователя для AEG Protect 1.150

 
 

45 

The load on the UPS should never exceed the specified rated load 
of the unit. If a unit overload occurs nevertheless (from 105% of 
the specified unit rated load) then the Fault LED lights up and an 
acoustic signal sounds (twice per second). The connected loads 
continue to be supplied for a certain length of time depending on 
the level of the overload. However, the connected load must be 
reduced without delay. 
Non-observance of the "unit overload" condition may cause the 
total loss of all UPS functions! 
Also avoid short-term unit overloads, which may, for example, 
occur when connecting a laser printer or laser fax machine. Do 
not connect any household appliances or machine tools to the 
UPS. 

 

Never connect or switch on any additional loads 
to the UPS if there is a mains failure, i.e. if the 
UPS is working in emergency power mode! 

As a rule, if there has never been an overload during normal 
mode, there will not be one in battery mode either. 

 

When the Fault LED lights up in connection with 
a continuous acoustic signal, this is an indication 
of a deactivating fault. Follow the instructions in 
chapter 0.