Справочник Пользователя для Panasonic PT-F100NTU

If the projector is aligned non-perpendicularly to the 
screen, or if the projection screen has an angled surface, 
you can correct keystone.

 

Setting range: -32 to +32

You can move the projected image for fine adjustment. 
Press I H to move horizontally and F G vertically.

If you have interference patterns of the projected image, 
which is sometimes referred to as moire or noise, you 
can minimize it by pressing I H to adjust the clock 
frequency.

If you require further adjustment for the same reason as 
the DOT CLOCK adjustment, you can fine adjust the 
timing of the clock. Press I H to adjust.

You can switch the aspect ratio manually when needed. 
Press I H to cycle through the options.

Q

The input signal will be projected without any 
change.

• You can correct the distortion ± 30 degrees from the 

plane. For a better quality image, installing the projector 
with a minimum of distortion is recommended.

• Some distortion may be retained for lens shift 

adjustment.

• The distortion of the Main menu screen is not 

correctable.

• The result of the keystone correction will affect the 

aspect ratio and the size of the image.

 

 

POSITION

H
V

• If the projecting signal’s dot clock frequency is higher 

than 108 MHz, the adjustment may not make a 
difference.

• DOT CLOCK needs to be adjusted before adjusting the 

CLOCK PHASE.

• If the projecting signal’s dot clock frequency is higher 

than 108 MHz, the adjustment may not make a 
difference.

• CLOCK PHASE is available with PC signals and the 

following COMPONENT connection.