Справочник Пользователя для Pelco C1555M-F
C1572M (9/05)
31
CM9700-CC1 Component Installation or Replacement
REMOVING THE CM9700-CC1 TOP COVER
1. Power off the CM9700-CC1.
2. Remove the ten screws that hold the top cover in place.
3. Tilt the top cover up at a slight angle as indicated by the dotted line in Figure 15, and then pull the cover backwards to remove the cover
from the front edge of the CM9700-CC1 chassis.
Figure 15. CM9700-CC1 Top Cover Removal
WARNINGS:
•
Installation or replacement of CM9700-CC1 components should be performed by qualified personnel only.
•
Electrostatic discharge (ESD) precautions must be observed when installing or replacing CM9700-CC1 components. Always wear a
grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
This section provides information about the following:
•
Removing the top cover of the CM9700-CC1 (the top cover must be removed before CM9700-CC1 components can be installed or
replaced)
replaced)
•
Installing or replacing a CM9700-SER card
For information about replacing the VGA card (CM9700-CC1-VID) in the CM9700-CC1, refer to the CM9700-CC1-VID VGA Video Card
Installation manual. For information about adding CM9700-SER-32 port expander units to the CM9700-CC1, refer to the CM9700-SER-32
Port Expander Installation/Operation manual.
Installation manual. For information about adding CM9700-SER-32 port expander units to the CM9700-CC1, refer to the CM9700-SER-32
Port Expander Installation/Operation manual.
WARNING:
Failure to power off the CM9700-CC1 can result in serious damage to the equipment.