Справочник Пользователя для Pelco C1555M-F

32

C1572M (9/05)

The CM9700-CC1 is shipped from the factory with a minimum of two CM9700-SER cards installed on the motherboard in ISA slots 1 and 2 (refer 
to Figure 16). You can install additional CM9700-SER cards into ISA slots 3 and 4, totaling a maximum of four cards. You can also replace an 
existing card. When installing or replacing a CM9700-SER card, you must set the interrupt and address jumpers on the new card.

Figure 16.  CM9700-CC1 with Top Cover Removed

To install or replace a CM9700-SER card, do the following:

1. Power off the CM9700-CC1.

2. Remove the top cover of the CM9700-CC1 (refer to the Removing the CM9700-CC1 Top Cover section).

3. If replacing an existing CM9700-SER card, remove the card from the ISA slot.

4. On the new CM9700-SER card, set the W1 interrupt (IRQ) and W2 address select jumpers (refer to Figure 17 and to Table E). Note that the 

jumper settings vary depending on the ISA slot into which the card is to be installed. If you are replacing a card, the jumper settings should 
match the settings on the card being replaced.

CM9700-SER card installation or replacement should be performed by qualified personnel only.

Electrostatic discharge (ESD) precautions must be observed when installing or replacing a CM9700-SER card. Always wear a 
grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.

Failure to power off the CM9700-CC1 can result in serious damage to the equipment.

CC1 CHASSIS, FRONT

CC1 CHASSIS, REAR

ISA SLOTS (DEFAULT 
CM9700-SER CARDS SUPPLIED IN 
ISA SLOTS 1 AND 2)

CM9700-SER CARD 
ACCESS SLOTS (SLOT 
COVERS REMOVED)