Справочник Пользователя для Barco 26-0507000-00

Rack-Mount Installation

BlendPRO-II units are designed to be rack mounted and are supplied with front rack-mount 
hardware.  Please note the following important points:

Rear rack-mount brackets are available as a kit, and are recommended for use 
when units are mounted in transit cases. 

When rack mounting the unit, remember that the maximum ambient operating 
temperature for the unit is 40 degrees C. 

Leave sufficient front and rear space to make sure that the airflow through the fan 
and vent holes is not restricted. 

When installing equipment into a rack, distribute the units evenly to prevent 
hazardous conditions that may be created by uneven weight distribution. 

Connect the unit only to a properly rated supply circuit. 

Reliable grounding (earthing) of rack-mounted equipment should be maintained.

Rack mount the unit from the front rack ears using four rack screws (not supplied).  
Rack threads may be metric or otherwise — depending upon the rack type.  

Install the lower of the two mounting holes first. 

„

Use the following steps to install power to the BlendPRO-II:

1.  Connect an AC power cord to the AC Power Connector on the rear of the 

BlendPRO-II, and then to an AC outlet.  

2.  Connect AC Power cords (or AC adapters) to all peripheral equipment, such as 

ScreenPRO-II systems, monitors and projectors. Please note:

Connect each unit only to a properly rated supply circuit. 

Reliable grounding of rack-mounted equipment should be maintained.