Справочник Пользователя для Barco 26-0507000-00
24
BlendPRO-II • User’s Guide
3. Installation
Power Installation
mçïÉê=`çêÇLiáåÉ=sçäí~ÖÉ=pÉäÉÅíáçå
BlendPRO-II is rated to operate with the following supplies:
•
Input Power: 100-240 VAC, 47-63 Hz
•
Power Consumption: 80 watts maximum
BlendPRO-II performs line voltage selection automatically, and no user controls are
required. The AC power cords must be accessible so that they can be removed during field
servicing.
required. The AC power cords must be accessible so that they can be removed during field
servicing.
Figure 3-1. Tandem Prong-type Plug
Warning
When the BlendPRO-II is used in the 230-volt mode, a UL
listed line cord rated for 250 volts at 15 amps must be used
and must conform to IEC-227 and IEC-245 standards. This
cord will be fitted with a tandem prong-type plug.
listed line cord rated for 250 volts at 15 amps must be used
and must conform to IEC-227 and IEC-245 standards. This
cord will be fitted with a tandem prong-type plug.
The rear panel ON/OFF switch does not disconnect the unit
from input AC power. To facilitate disconnection of AC power,
the power cord must be connected to an accessible outlet
near the unit.
from input AC power. To facilitate disconnection of AC power,
the power cord must be connected to an accessible outlet
near the unit.
Building Branch Circuit Protection: For 115 V use 20 A, for
230 V use 8 A.
230 V use 8 A.
Avertissement
La choix de la ligne de voltage se réalise automatiquement
par le BlendPRO-II Transformateur Graphique. On n'a pas
besoin du controller usager pour la choix de la ligne de
voltage.
par le BlendPRO-II Transformateur Graphique. On n'a pas
besoin du controller usager pour la choix de la ligne de
voltage.
Warnung
Das BlendPRO-II gerät mu beim Anschlu an 240V ~ mit einer
vom VDE auf 250V/10A geprüften Netzleitung mit einem
Schukostecker ausgestattet sein.
vom VDE auf 250V/10A geprüften Netzleitung mit einem
Schukostecker ausgestattet sein.