Справочник Пользователя для Acer G901

 3 Hardware configuration

76

The table below lists the LED states and the drive status indicated by 
each state.

Installing and removing a hot-swap drive 
in a carrier

To install a hot-swap drive in a carrier

Before you can install a drive in the hot-swap drive bay, you must 
install the drive into a drive carrier.  To install a hot-swap drive in a 
carrier:

1

If the plastic air baffle is installed in the carrier, remove the four 
screws that attach the air baffle to the carrier.  

Save the air baffle in case you later remove a drive.

Solid green

The hard drive is present and powered on.

Flashing green

The hard drive is active.

Solid yellow

There is an asserted fault status on the hard drive.

Flashing yellow

A rebuild of the hard drive is in progress.

Off

The hard drive is not powered on.

  Figure 38 - Removing a plastic air baffle from a carrier

BB!H:11!vh!.!FO/cppl!!Qbhf!87!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN