Справочник Пользователя для Acer G901
3 Hardware configuration
78
To remove a hot-swap drive from a carrier
1
Remove the carrier and drive from the drive bay.
2
Remove the four screws that secure the drive to the carrier.
3
Place the drive on an antistatic surface.
4
If you are going to reinstall the carrier without a drive, you must
first reinstall the air baffle in the carrier.
first reinstall the air baffle in the carrier.
Removing and installing hot-swap disk drives
Important: Do not leave any drive slots without a drive or air
baffle installed in the carrier. An empty carrier installed in a drive
slot reduces cooling efficiency and can affect performance or
cause damage due to overheating.
baffle installed in the carrier. An empty carrier installed in a drive
slot reduces cooling efficiency and can affect performance or
cause damage due to overheating.
To install a hot-swap disk drive
1
Depress the green clip at the end of the plastic carrier handle.
2
Pull the handle out to disengage the carrier handle latch from the
locking slot at the top of the drive bay.
locking slot at the top of the drive bay.
Label
Description
A
SCA connector
B
Drive
C
Carrier
D
Plastic rail
E
Screw
BB!H:11!vh!.!FO/cppl!!Qbhf!89!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN