Справочник Пользователя для Toshiba Satellite R10
2 Troubleshooting
2.11 Modem Troubleshooting
Satellite R10 Maintenance Manual (960-509)
2-47
2.11 Modem Troubleshooting
To check if the modem is defective or malfunctioning, follow the troubleshooting procedures
below as instructed.
below as instructed.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1
Diagnostic Test Program Execution Check
Execute the Modem test program available as part of the maintenance test program. This
program checks the modem. See Chapter 3 for information on how to perform the test.
program checks the modem. See Chapter 3 for information on how to perform the test.
If any error is detected by the test, go to Procedure 2.
Procedure 2
Connector Check and Replacement Check
The Modem jack (RJ11) is mounted on the system board and MDC is connected to the system
board. If the modem malfunctions, the connection may be bad or the MDC or system board
might be faulty.
board. If the modem malfunctions, the connection may be bad or the MDC or system board
might be faulty.
Disassemble the computer following the steps described in Chapter 4 and perform the
following checks:
following checks:
Check 1
Make sure the MDC is firmly connected to the PJ3020 and the MDC cable is
connected to the PJ3021 on the system board.
connected to the PJ3021 on the system board.
If any connector is disconnected, connect it firmly and return to Procedure 1. If
there is still an error, perform Check 2.
there is still an error, perform Check 2.
Check 2
The MDC may be faulty. Replace it with a new one following the steps in Chapter
4. If the modem is not still working properly, perform Check 3.
4. If the modem is not still working properly, perform Check 3.
Check 3
The system board may be faulty. Replace it with a new one following the
instructions in Chapter 4.
instructions in Chapter 4.