Справочник Пользователя для Metrologic Instruments IS8000

 

 

6 

 

 

When attached, beeper tones from the scanner are emitted from both the 
scanner speaker and external speaker to serve as an audible indication of the 
operation of the scanner.

 

 

 

There are 6 beeper options available:  

 Normal 

Tone 

 Tone 

2 

 Tone 

4 

 Tone 

1 

 Tone 

3 

 No 

Tone 

 
Beeper tones can be adjusted by using the MetroSet

®

 program. 

 

To avoid potential problems, do not power up the scanner until the 
communication cable is secured to the host. 

 
1.  Turn off the host system. 

 

2. Connect 

the 

communications cable to 
the HoloTrak

®

 and to the 

host. 

 

3.  Connect the External 

MX008 cable to the 
HoloTrak

 

and the MX008. 

 

4.  Check the AC input 

requirements of the power 
supply for the scanner and 
the MX008 to make sure 
the voltages match the AC 
outlets. 

 

5.  Connect the power supply 

to the HoloTrak.  

 

6.  Plug the power supplies 

into the AC outlet. 

 
7.  Power up the host system 

 

 

 
 

 

 

 

 

To maintain compliance with applicable standards, all circuits connected to the scanner must meet 
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1. 

 

To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950-
1, the power source should meet applicable performance requirements for a limited power source.