Справочник Пользователя для Metrologic Instruments IS8000

 

 

7

 

 

A Non-Decode Hand-Held Scanner can be connected to an IS8000 series fixed 
scanner.

 

 

 
To avoid potential problems, do not power up the scanner until the 
communication cable is secured to the host.

 

 

 

1.  Turn off the host 

system. 

 

2. Connect 

the 

communications cable 
to the HoloTrak

®

 and to 

the host. 

 

3. Connect 

the 

communication cable of 
the hand-held scanner 
to the HoloTrak. 

 

4.  Check the AC input 

requirements of the 
power supply for the 
scanner to make sure 
the voltage matches 
the AC outlet. 

 

5.  Connect the power 

supply to the HoloTrak.  

 

6.  Plug the power supply 

into the AC outlet. 

 

7.  Power up the host 

system. 

 

When the hand-held scanner first receives power, it will immediately go 
through a self-diagnostic routine, then the green and red LEDs will flash, 
and the unit will beep once.

 

 

 
 

 

To maintain compliance with applicable standards, all circuits connected to the scanner must meet 
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1. 

 

To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950-
1, the power source should meet applicable performance requirements for a limited power source.