Справочник Пользователя для Metrologic Instruments IS8000

 

 

14 

 

 

To avoid potential problems, do not power up the scanner until the 
communication cable is secured to the host.

 

 

 

1. Turn 

off the PC after installing the MetroSet 2 program.  

 
2.  Connect the communication cable to the scanner and to the RS-232C 

serial port (COM1 or COM2) located on the PC.

 

 

 
3.  Check the AC input requirements of the transformer to make sure the 

voltage matches the AC outlet.  An easily accessible socket-outlet 
should be installed near the equipment.

 

 

 

4.  Power up the scanner. 
 
5.  Turn on the PC. 
 
6.  From your Start menu choose Programs, MetroSet 2, MetroSet 2. 
 
7. Select 

 as the unit to configure. 

 
8. Then 

choose 

Configure. 

 
9.  For detailed instructions on the configuration options available choose 

Help from the menu bar. 
 
 
 
 
 

Metrologic’s HoloSet

®

 program can also be used to configure the scanner. 

 
 
 
 
 
 
 

 

To maintain compliance with applicable standards, all circuits connected to the scanner must meet 
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1. 

 

To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950-
1, the power source should meet applicable performance requirements for a limited power source.