Инструкции Пользователя для Bose PDF259774_00

Скачать
Страница из 64
 
8
April 12, 2001
PDF259774_00
 
System Setup
 
Setting up the Wave/PC
 
 
 remote control
 
WARNING: 
 
Keep the remote control battery away from children. It may cause a fire or chem-
ical burn if mishandled. Do not recharge, disassemble, heat above 100˚C (212˚F), or inciner-
ate. Dispose of used battery promptly. 
 
CAUTION: 
 
Danger of explosion if battery is incorrectly replaced. Replace only with the same 
or equivalent type.
 
Note: 
 
Some remote control functions will not work until your Wave/PC unit is connected to 
your computer and the Wave/PC software is installed.
 
Your remote control may be one of two types. Each is identified by the way the battery com-
partment unlocks to install or replace the battery (Figure 2 or Figure 3).
1.
Place the remote control face down on a flat surface.
2.
A. Insert the tip of a ballpoint pen into the slot. Push to the side (as shown) and hold. 
Slide the battery compartment open with your finger.
B. Using your finger, push the tab lock to the side (as shown) and hold. Slide the battery 
compartment open.
 
Figure 2
 
Locating the slot-type 
safety lock
 
Figure 3
 
Locating the tab-type safety 
lock
 
Note: 
 
Use only a Duracell, Eveready, Maxell, or Toshiba CR2032 or DL2032 lithium battery 
(available at electronics stores). If you have difficulty finding a replacement battery, contact 
Bose
 
®
 
 Customer Service. (See phone numbers on the inside back cover.)
 
3.
Keeping the remote control face down, insert the new battery into the compartment with 
the + symbol facing up.
4.
Gently slide the battery compartment closed. It locks automatically.
See operating
instructions for types of
battery to be used
See operating
instructions for types of
battery to be used
Slot
+ Symbol
Se
e o
pe
ra
tin
g
in
stru
ctio
ns
 fo
r ty
pe
s o
f
ba
tte
ry
 to
 b
e u
se
d
See operating
instructions for types of
battery to be used
Tab
+ Symbol