Справочник Пользователя для Ingersoll-Rand 4581740

04581740_ed2 

31

121

Powerhead – MCE step sequence error

122

Powerhead – MCE software fault

123

Powerhead – MCE IGBT fault

124

Powerhead – MCE low bus voltage fault

125

Powerhead – MCE hardware watchdog fault

126

Powerhead – MCE calibration failed due to EEPROM mode

127

Powerhead – MCE calibration failed due to offset

128

Powerhead – MCE calibration failed due to shunt calibration

129

Powerhead – spindle was not known to be stopped at cycle complete

130

Powerhead – timeout on start

131

Powerhead – configurations do not match

132

Powerhead – invalid tool connected

133

Powerhead – no tool connected

134

Powerhead – spindle stopped at a sync point

135

Powerhead – spindle in diagnostics mode

To access and use the Cycle Log:

1.  Press the Stats button on the Insight controller.
2.  On the Statistics menu, select Cycle Log and press Enter.
3.  Scroll through the cycles that have been recorded using the arrow keys.
4.  Move the cursor to the C (Clear) button and press Enter to clear all existing cycle data.
 

NOTE: Although using the C button clears data on up to 1,000 cycles, it does not reset the counter. The counter 

continues up to 9,999, unless reset with the ICS Software.

Clear Cycle Data This button will clear the cycle log data table for the displayed spindle.

This window displays the cycle log summary table. Additional information on the parameters 

displayed is described below.

The Spindle Statistics screen displays useful statistics that have been calculated from the data collected. Note that on 

the left side of the screen displays the statistical data for all the fastenings performed since the statistics were last reset 

(the Population Stats), while the right side the statistics for a subset of the cycle (the Sample Stats) The sample size for 

Sample Stats is set to 25 by default, but this parameter may be changed in the Stats Settings screen. Both Population 

and Sample statistics may also be reset on that screen.

Figure 27 - Spindle Statistics

Note that you must use the dropdown box to select the Configuration from which you wish to view the spindle 

statistics. These statistics are only available for the first eight Configurations. The ICS Software can be set up to calculate 

statistics for further Configurations.

To access and use the Spindle Statistics:

1.  Press the Stats button on the Insight controller.