Справочник Пользователя для Intel SERVER CHASSIS SR2500 SR2500

Intel® Server System SR2500AL 

 

The Intel

®

 Local Control Panel module includes the control panel interface board and an 

interposer board.  Connectors on the control panel interface board are cabled to matching 
connectors on the interposer board.  When the pre-assembled control panel module is installed 
into the chassis, a card edge connector on the interposer card is blind mated with a slot edge 
connector on the backplane.  This section will define the pin-out for each connector and header 
found on both the control panel interface board and interposer board. 

• 

A 64-pin card edge connector on the interposer board is used to route signals to/from 
the backplane to the control panel interface board. The backplane is used as a conduit 
for communication to the server board. 

• 

Signals from the card edge connector are routed to control panel interface board through 
matching 50-pin connectors on the interposer board and control panel interface board. 
The 50-pin connectors are attached using a small 50-pin flat cable.  

• 

USB signals from the card edge connector are routed to the control panel interface 
board through matching 10-pin connectors on the interposer board and control panel 
interface board. The 10-pin connectors are attached using a small 10-pin round cable. 

• 

A 4-pin IPMI header (not used).  

•  A 4-pin NMI/Temp Sensor header.  

The following tables provide the pin-outs for each connector. 

    A1      GND 

    B1      1_WIRE_BUS 

    A2      VGA_VSYNC_FP_L 

    B2      P5V 

    A3      GND 

    B3      P5V 

    A4      VGA_HSYNC_FP_L 

    B4      P5V 

    A5      GND 

    B5      VGA_INUSE_L 

    A6      VGA_BLUE_FP 

    B6      GND 

    A7      GND 

    B7      P5V_STBY 

    A8      VGA_GREEN_FP 

    B8      GND 

    A9      GND 

    B9      FAULT_LED_5VSB 

    A10    VGA_RED_FP 

    B10    GND 

    A11    GND 

    B11    FP_SYS_FLT_LED1_R_L 

    A12    GND 

    B12    FP_ID_SW_L 

    A13    FP_RST_BTN_L 

    B13    FP_ID_LED_R_L 

    A14    GND 

    B14    NC_IPMB_5VSB_SDA 

    A15    NC_FP_CHASSIS_L 

    B15    NC_IPMB_5VSB_SCL 

    A16    GND 

    B16    GND 

    A17    BP_I2C_5V_SDA 

    B17    NIC1_ACT_LED_L 

    A18    BP_I2C_5V_SCL 

    B18    NIC1_LINK_LED_R_L 

    A19    GND 

    B19    FP_PWR_BTN_L 

    A20    FP_NMI_BTN_L 

    B20    PWR_LED_5VSB 

    A21    GND 

    B21    HDD_LED_P3V3_A 

    A22    USB_DP2_FP 

    B22    GND 

    A23    USB_DN2_FP 

    B23    GND 

    A24    GND 

    B24    NIC2_ACT_LED_L 

    A25    GND 

    B25    NIC2_LINK_LED_R_L