Справочник Пользователя для Wagner SprayTech 0558011 0558012 0558013 0558028 0558096 0558097 0558098

 

4 

ProSpray 3.25

Safety Regulations 

This manual contains information that must be read and understood 
before using the equipment. When you come to an area that has one of 
the following symbols, pay particular attention and make certain to heed 
the safeguard.

•  NEVER aim the gun at any part of the body.

•  NEVER allow any part of the body to touch the fluid

stream. DO NOT allow body to touch a leak in the fluid

hose.

•  NEVER put your hand in front of the gun. Gloves will

not provide protection against an injection injury.

•  ALWAYS lock the gun trigger, shut the fluid pump off

and release all pressure before servicing, cleaning 
the tip guard, changing tips, or leaving unattended. 
Pressure will not be released by turning off the engine. 

The PRIME/SPRAY valve or pressure bleed valve

must be turned to their appropriate positions to relieve 
system pressure.

•  ALWAYS keep tip guard in place while spraying. The

tip guard provides some protection but is mainly a 
warning device.

•  NEVER use a spray gun without a working trigger lock

and trigger guard in place.

•  ALWAYS remove the spray tip before flushing or

cleaning the system.

•  The paint hose can develop leaks from wear, kinking

and abuse.  A leak can inject material into the skin.  
Inspect the hose before each use.

•  All accessories must be rated at or above the

maximum operating pressure range of the sprayer.  
This includes spray tips, guns, extensions, and hose.

PREVENTION:

•  Provide extensive exhaust and fresh air introduction

to keep the air within the spray area free from 

accumulation of flammable vapors.

•  Avoid all ignition sources such as static electricity

sparks, electrical appliances, flames, pilot lights, hot

objects, and sparks from connecting and disconnecting 
power cords or working light switches.

•  Plastic can cause static sparks. Never hang plastic

to enclose spray area.  Do not use plastic drop cloths 

when spraying flammable materials.

•  Always flush unit into separate metal container, at low

pump pressure, with spray tip removed.  Hold gun 

firmly against side of container to ground container and

prevent static sparks.

•  Do not smoke in spray area.

•  Fire extinguisher must be present and in good working

order.

•  Place sprayer at least 6.1 m (20 feet) from the spray

object in a well ventilated area (add more hose if 
necessary).  Flammable vapors are often heavier than 
air.  Floor area must be extremely well ventilated.  The 
pump contains arcing parts that emit sparks and can 
ignite vapors. 

•  The equipment and objects in and around the spray

area must be properly grounded to prevent static 
sparks.

•  Use only conductive or earthed high pressure fluid

hose.  Gun must be earthed through hose connections.

•  Power cord must be connected to a grounded circuit

(electric units only).

•  The unit must be connected to an earthed object. Use

the green earthing wire to connect the unit to a water 
pipe, steel beam, or other electrically earthed surface.

•  Follow material and solvent manufacturer’s warnings

and instructions. Be familiar with the coating material’s

MSDS sheet and technical information to ensure safe 
use.

•  Do not use materials with a flashpoint below 21° C

(70° F). Flashpoint is the temperature at which a fluid

can produce enough vapors to ignite.

•  Use lowest possible pressure to flush equipment.

Uncontrolled Copy