Справочник Пользователя для Ryobi RY41140

See Figure 3.
The following tools (not included or drawn to scale) are 
needed for assembly:


Phillips screwdriver

The line cutting blade on the grass deflector is sharp. 
Avoid contact with the blade. Failure to avoid contact 
can result in serious personal injury.



Remove supplied screws with a phillips screwdriver from 
the 

motor housing

.



Line up the screw holes in the grass deflector with the 
holes in the motor housing.



Install supplied screws and tighten by turning clockwise 
with a phillips screwdriver.



Slowly pull loop against cord retainer until the slack is 
 removed.



Plug product into extension cord.

Failure to remove all excess cord slack from ex-

tension cord retainer could result in plug loosening from 
receptacle.

 NOTE:  Use only approved outdoor extension cords.

Always use cord retainer to properly attach extension 
cord to string trimmer. Failure to use cord retainer may 
result in damage to string trimmer and/or extension cord.

See Figure 6.


To start the string trimmer, press the switch trigger.



To stop the string trimmer, release the switch trigger.

See Figure 7.
The angle of the front handle can be adjusted 180°.


Unplug the string trimmer.



 Set the trimmer on a flat surface and turn the knob  

counterclockwise to loosen the handle.



  For trimming, adjust the handle upward.



  For edging, adjust the handle downward.



 Turn the knob clockwise until the handle is securely 

tightened.

Do not allow familiarity with products to make you care-
less. Remember that a careless  fraction of a second is 
sufficient to inflict severe injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1. Failure to do so could result in 
objects being thrown into your eyes, resulting in possible 
serious injury.

Never use blades, flailing devices, wire or rope on this 
product. Do not use any attachments or accessories not 
recommended by the manufacturer of this product. The 
use of attachments or accessories not recommended 
can result in serious personal injury.

Before each use, inspect the entire product for damaged, 
missing, or loose parts such as screws, nuts, bolts, caps, etc.  
Tighten securely all fasteners and caps and do not operate 
this product until all missing or damaged parts are replaced.  
Please call 1-800-242-4672 or contact an authorized service 
center for assistance.

See Figure 6.
This product is designed with a cord retainer that prevents 
the extension cord from being pulled loose while using.


Form a loop with the end of the extension cord.



Insert loop portion of extension cord through opening in 
the bottom of the rear handle and place over cord retainer.