Справочник Пользователя для Hitachi CG 22EAB

7

Loosen tube locking bolt (1) about ten turns so that 

the bolt point will not obstruct drive shaft tube to be 

inserted. When inserting drive shaft tube, hold the 

tube locking bolt outward preventing inside fi tting 

from obstructing as well.

Insert the drive shaft into the clutch case of the 

engine properly until the marked position (2) on the 

drive shaft tube meets the clutch case.

Some models may come with the drive shaft already 

installed.

1

2

1

2

Fig. 1

  When it is hard to insert drive shaft up to the 

marked position on the drive shaft tube, turn 

drive shaft by the cutter mounting end clockwise 

or counter-clockwise. Tighten tube locking bolt 

lining up the hole in the shaft tube. Then tighten 

clamp bolt securely.

1.  Join the attachment in place of it.

2.  Make sure the lock pin (3) fi ts in the location hole 

(4) of tube and that the tube will not come off . 

(Fig. 2)

3.  Tighten the knob nut (5) securely. (Fig. 2)

3

5

4

Fig. 2

6

Fig. 3

Attach the handle to the drive shaft tube with the 

angle towards the engine.

Adjust the location to the most comfortable position 

before operation.

  If your unit has handle location label on drive 

shaft tube, follow the illustration.

Remove the handle bracket (7) from the assembly. 

(Fig. 4) 

Place the handles and attach the handle bracket with 

four bolts lightly. Adjust to appropriate position. Then 

attach it fi rmly with the bolts.

7

Fig. 4

000Book_CG22EAS_US.indb   7

000Book_CG22EAS_US.indb   7

2010/01/14   9:49:37

2010/01/14   9:49:37