Справочник Пользователя для Hitachi CG 22EAB

9

Fig. 11

  The guard bracket may come already mounted to 

the gear case on some models.

Install the blade guard on drive shaft tube against 

angle transmission. Tighten the guard bracket fi rmly 

so that the blade guard does not swing or move 

down during operation.

Install the blade guard to the guard bracket, which 

also secures the guard to the gear case using the 

two guard mounting screws.

When using a trimmer head with two piece type 

blade guard, attach the guard extension to the blade 

guard. (Fig. 12)

Fig. 12

○  When attaching the guard extension to the blade 

guard, the sharp line limiter must be removed 

from the blade guard, (if so installed).

○  If your unit has guard location label on drive shaft 

tube, follow the indication.

○ To remove the guard extension, refer to the 

drawings. Wear gloves as the extension has a 

sharp line limiter, then push the four square tabs 

on the guard one by one in order. (Fig. 13)

Fig. 13

1. Function

  Automatically feeds more nylon cutting line 

when it is tapped at low rpm (not greater than 

4,500 rpm).

000Book_CG22EAS_US.indb   9

000Book_CG22EAS_US.indb   9

2010/01/14   9:49:37

2010/01/14   9:49:37