Справочник Пользователя для Hotpoint HAGL 51 K

PLEASE PHONE US TO REGISTER YOUR APPLIANCE  AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

The appliance must only be installed by a competent 
person. In the UK, CORGI registered installers 
undertake to work to safe and satisfactory standards.
Before moving your cooker check that it is cool, and 
switch off at the cooker control unit. Movement of your 
cooker is most easily achieved by lifting the front as 
follows:
Open the grill door sufficiently to allow a comfortable 
grip on the underside front edge of the oven roof, 
avoiding any grill elements.
Note: Take care in moving the cooker as it is heavy. 
Take care to ensure that any floor covering is not 
damaged. (FIG. C)
Splashplate optional, apply to Parts Department (see 
Back Cover for contact number.)
The following instructions should be read by a qualified 
technician to ensure that the appliance is installed, 
regulated and technically serviced correctly in 
compliance with current regulations.

Important: remember to unplug the appliance from the 
mains before regulating the appliance or carrying out 
any maintenance work.

Important: this unit may be installed and used only in 
permanently ventilated rooms according to the British 
Standards Codes Of Practice: B.S. 6172/B.S. 5440, 
Par. 2 and B.S. 6891 Current Editions. The following 
requirements must be observed:

a) The cooker should not be installed in a bed sitting 

room with a volume of less than 20m

3

. If it is installed 

in a room of volume less than 5m

3

 an air vent of 

effective area of 110cm

2

 is required, if it is installed 

in a room of volume between 5m

3

 and 10m

3

 a 

supplementary airvent area of 50cm2 is required, 
if the volume exceeds 11m

3

 no airvent is required. 

However, if the room has a door or a window which 
opens directly to the outside no air vent is required 
even when the volume is between 5m

3

 and 11m

3

.

b) During prolonged use of the appliance you may 

consider it necessary to open a window to the 
outside to improve ventilation.

c) If there are other fuel burning appliances in the 

same room, B.S.5440 Part 2 Current Edition, should, 
be consulted to determine the requisite air vent 
requirements.

For a correct installation of the cooker the following 
precautions must be followed:
The height of the cooker can be adjusted by means of 
adjustable feet in the plinth (900mm - 915mm). Adjust 
the feet by tilting the cooker from the side. Then install 
the product into position.
NOTE: This appliance must not be fitted on a platform.
The cooker is designed to fit between kitchen cabinets 
spaced 500mm apart. The space either side need 
only be sufficient to allow withdrawal of the cooker for 
servicing. It can be used with cabinets one side or 
both as well as in a corner setting. It can also be used 
free-standing.
Adjacent side walls which project above hob level, 
must not be nearer to the cooker than 150mm or 65mm 
(Fig. A) and should be protected by heat resistant 
material. Any overhanging surface or cooker hood 
should not be nearer than 750mm. (Fig.A)

a) The cooker may be located in a kitchen, a kitonen/

diner or bed sitting room, but not in a bathroom or 
shower room.

b) The hoods must be installed according to the 

requirements in the hood handbook.

c) The wall in contact with the back of the cooker must 

be of flameproof material.

d) The cooker is fitted with a safety chain that must be 

attached to a hook, secured to the wall behind the 
appliance.

  Note: some models can have their gas connection 

inverted. It is important to make sure the safety chain 
is always situated on the side which corresponds to 
the hose holder (Fig. B).

65 mm min

500 mm min

400 mm min

400 mm min

750 mm min

65 mm min

65 mm min

150 mm min

500 mm min

750 mm min

Fig. A