Справочник Пользователя для Hotpoint HAGL 51 K

PLEASE PHONE US TO REGISTER YOUR APPLIANCE  AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

c) Minimum regulation of the hob burners:
•  turn the tap to minimum;
•  remove the knob and adjust the regulation screw, 

which is positioned in or next to the tap pin, until the 
flame is small but steady.

! In the case of liquid gas, the regulation screw must 

be screwed in to the 
bottom.

•  check that the flame 

does not turn off when 
you turn the tap quickly 
from high to low.

d) Regulating the primary 

air of the burners:

The primary air of the 

burners requires no regulation.

In order to adapt the oven to a different type of gas 
with respect to the gas for which it was manufactured 
(indicated on the label), follow these simple steps:

a) Replacing the oven burner nozzle

•  open the oven door fully
•  pull out the sliding oven bottom

•  Pry the fixing tab “V” and remove the oven burner
•  Unscrew the oven burner nozzle using the socket 

spanner for the nozzles “Z”, or a 7 mm socket 
spanner, and replace it with a nozzle suited to the 
new type of gas (see Table 1).

  Take particular care handling the spark plug wires 

and the thermocouple pipes.

•  Replace all the parts, following the steps described 

above in the reverse order.

b) Minimum regulation of the gas oven burner with 

thermostat:

•  light the burner as described in the paragraph “the 

oven knob” of the instruction booklet.

•  turn the knob to Max for about 10 minutes and then 

turn the knob to the Min setting;

•  remove the knob;
•  regulate the screw positioned outside the thermostat 

pin until the flame is small but steady.

! In the case of liquid gas, the regulation screw must 
be screwed in to the bottom.

•  check that the burner does not turn off when you 

turn the knob from Max to Min and and when you 
open and close the oven door quickly.

Replacing the nozzle of the grill burner:

•  remove the screw and then slide out the grill burner 

“V” (see Fig. E);

•  unscrew the grill burner nozzle using the special 

socket spanner for the nozzles (see Fig. F) or better 
still a 7 mm socket spanner; replace the nozzle with 
a nozzle for the new type of gas (see table 1).

unscrew the two screws and take off the shield 
protecting the burner (in main oven burner only).

•