Справочник Пользователя для AEG PV.500-MH
Protect PV.500_MH Operating Instructions
80000043212 BAL
53 of 68
Connections:
CN1:
CN1:
Internal inverter bus and power supply
MOD1: Ethernet
connection
CN5:
Interface for firmware update
Configuration jumpers:
CN3:
CN3:
All closed (default)
LED signals:
Green LED (H1):
The green LED on the assembly indicates the global status of the
assembly. The following signals are possible:
The green LED on the assembly indicates the global status of the
assembly. The following signals are possible:
LED Jumper
Meaning
Flashing CN3
Start-up/error
On CN3
Ready
Flickering CN3 Ethernet
CAN communication
Green network LED (MOD1):
The green LED indicates communication on the network.
The green LED indicates communication on the network.
Yellow network LED (MOD1):
The yellow LED remains on permanently if an Ethernet network is
connected.
The yellow LED remains on permanently if an Ethernet network is
connected.
7.2.4 Installation of the COM Server
The COM server uses a communication module from Digi ("Digi
Connect ME"). In order to communicate via the COM server, it
must be integrated into the network and a virtual COM port must
be set up on a computer. The "Digi Device Discovery" tool and a
Digi RealPort driver are required for this purpose. You can find
these tools at www.digi.com/support or at www.aegps.com.
Connect ME"). In order to communicate via the COM server, it
must be integrated into the network and a virtual COM port must
be set up on a computer. The "Digi Device Discovery" tool and a
Digi RealPort driver are required for this purpose. You can find
these tools at www.digi.com/support or at www.aegps.com.
Network factory settings for the COM server:
IP address:
IP address:
10.10.10.0
Subnet mask:
255.255.0.0
Default gateway:
0.0.0.0