Справочник Пользователя для Pelco FR8302A

C1649M  (1/06)

11

The following items are supplied:

1

FR8302A receiver

1

Regulated switching power supply with four plug adapters (North American, Australian, U.K., 
and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1

Wall clip with two 4-40 x .250-inch Phillips pan head screws with lock washers (for attachment 
of single module to wall)

1 

FR8302A Fiber Receiver Installation manual (this manual)

The FR8302A receiver can be mounted into a rack or can be used as a standalone module. As a 
standalone module, the unit can be placed on a desktop or can be mounted to a wall. 

The FR8302A receiver can be installed into an RK5000 Series rack mount chassis, which can be 
mounted into an industry-standard 19-inch (48.26 cm) equipment rack. The RK5000 Series rack mount 
chassis includes the following models:

•

RK5000PS-3U and RK5000-3U:  Designed to accommodate fiber optic modules as follows:

–

The RK5000PS-3U rack mount chassis provides 12 module slots and a power supply. 

–

The RK5000-3U rack mount chassis provides 14 module slots (a power supply is not 
included). Power to the modules can be supplied using the optional external power 
supply (EPS5000-120).

For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis 
Installation manual.

•

RK5000PS-5U:  Designed to accommodate Endura

™

 modules but can also accommodate fiber 

optic modules with the use of the RK5001-1UEXP adapter kit. The RK5001-1UEXP adapter kit 
is required for installation of the FR8302A receiver into the RK5000PS-5U chassis.

For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount Chassis 
Installation manual.

The FR8302A receiver can be mounted to a wall in the following ways:

•

Using the supplied wall clip for attachment of a single module to a wall. For installation 
instructions, refer to the Mounting the FR8302A Receiver Using the Wall Clip section below.

•

Using the optional WM5001 wall mount kits, which are designed for mounting of single-width 
fiber optic modules. The WM5001-3U base kit allows mounting of a single module to the wall. 
The WM5001-3UEXP expansion kit allows mounting of an additional module. It is 
recommended that a maximum of three expansion kits be used with the base kit, allowing a 
maximum of four single-width modules to be mounted to the wall.