Справочник Пользователя для Mitsubishi Electronics FR-F740P

Perform the following procedure to calibrate terminal FM using the operation panel FR-DU07. Refer to page 159 for
the details of parameters. 

⋅ Calibration can also be made for external operation. Set the frequency in External operation mode, and make calibration in

the above procedure.

⋅ Calibration is available even during operation.

⋅ For the operating procedure using the parameter unit (FR-PU04/FR-PU07), refer to the parameter unit instruction manual.

♦ Parameters referred to ♦

Press        to return to the               indication (step 8).

13. 

Press        .   Setting is complete.

2. 

Press          to choose the parameter 

      setting mode.

3. 

Analog indicator

6. 

Press         to set.

7. 

Turn          until                appears.

5.

 Turn           to change it

     to the setting value of "     ".

4.

 Press         to read the present set value.

     "             " (initial value) appears.

1.

Confirmation of the RUN indicator and 

     operation mode indicator

8. 

Press         to display              .

10.

 Press          to enable setting.

11. 

If the inverter is at a stop, (press

                  or         ) to start the inverter.

        (Motor needs not be connected.)

12.

 Turn          to adjust the indicator needle 

         to the desired position.

(    )   )

By turning         , you can read another parameter.

The parameter 
number read 
previously appears.

(When 

Pr. 54=1)

Press        twice to show the next parameter (             ).

Display

Operation

9.

Turn          until                appears.

    Set to

C0 FM terminal calibration.

C0 to C7 
setting 
is enabled.

The monitor set to 

Pr. 54 FM terminal 

function selection is displayed.