Справочник Пользователя для Mitsubishi Electronics AJ65BT-D75P2-S3
13 - 9
MELSEC-A
13 COMMON FUNCTIONS
(1) "Module status" display details
"Module status" displays the operation status of the D75P2.
17-segment LED
Axis indicator LED
Details
RUN
Operating axis flickers.
During axis operation
TEST
All axes turn on.
During test mode
IDL Off
During
standby
ERR
LED of axis in error flickers. During error occurrence
(2) Axis status" display details
"Axis status" displays the operation statuses of the axes.
The status of one axis is switched to that of the other every 0.5 seconds.
The status of one axis is switched to that of the other every 0.5 seconds.
17-segment LED
Axis indicator LED
Details
IDLE
The lit LED changes every
0.5 seconds.
0.5 seconds.
During standby
STOP During
stop
JOG
During JOG operation
MANP
During manual pulse generator operation
OPR
During zero point return
POSI During
position
control
VELO
During speed control
V- P
During speed control of speed/position
changeover control
changeover control
V -P
During position control of speed/position
changeover control
changeover control
BUSY
During condition waiting, etc.
E***
At error occurrence
Error number display
When the axis has an error, the error number that has occurred in that axis
is displayed 0.5 seconds, and the status of the next axis is then displayed.
is displayed 0.5 seconds, and the status of the next axis is then displayed.
(3) "I/O information n" display details
"I/O information n" displays the status of each signal.
The "Axis indicator LED" turns on.
The "Axis indicator LED" turns on.
17-segment LED
Axis indicator LED
Details
SVON
Lit when the displayed
signal is ON.
signal is ON.
Drive unit READY signal
Z-ON
Zero point signal
ULMT
Upper limit signal
LLMT
Lower limit signal
V-P Speed/position
changeover
signal
DOG
Near-point dog signal
(4) Other display details
The following error message is displayed in the 17-segment LED independently
of the mode.
of the mode.
17-segment LED
Axis indicator LED
Details
FALT
This error message is displayed when the flash
ROM value becomes illegal.
Execute initialization.
The cause of the error is a hardware fault if the
error message is displayed after execution of
initialization.
ROM value becomes illegal.
Execute initialization.
The cause of the error is a hardware fault if the
error message is displayed after execution of
initialization.