Руководство Пользователя для American Megatrends 1108-j
Hardware Installation
3
2 Hardware
Installation
Overview
This chapter provides you with instructions on how to setup the hardware portion of the StorTrends 1108. This
manual assumes that you are familiar with the basic installation of the CPU and memory module.
manual assumes that you are familiar with the basic installation of the CPU and memory module.
Warning
When working inside the chassis, unplug both power cables.
When installing this unit, both power outlets that supply
power to the two power supplies must be easily accessible.
Access to these outlets must not be blocked or obstructed in
any way.
Installation Steps
The table below lists the steps required to install the StorTrends 1108
Step
Description
Turn to page
1
Unpack and Inspect the Contents
3
2
Install the CPU and Memory
4
3
Install into Rack
6
4
Connect Power and Network Cables
7
5
Install Hard Drives
7
6
Power On
9
Step 1 Unpack and Inspect the Contents
Step
Action
1
Inspect the cardboard carton for obvious damage. If damaged, call 770-246-8600. Leave it
in its original packing.
in its original packing.
2
Perform all unpacking and installation procedures on a ground-connected anti-static mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat or use a sheet
of conductive aluminum foil grounded through a 1-megohm resistor instead of the anti-static
mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat or use a sheet
of conductive aluminum foil grounded through a 1-megohm resistor instead of the anti-static
mat.
Similarly, a strip of conductive aluminum foil wrapped around the wrist and grounded
through a 1 megohm resistor serves the same purpose as the wristband.
through a 1 megohm resistor serves the same purpose as the wristband.