Руководство Пользователя для Netopia 3220-h

Using the Command Line Interface

Cayman 3220-H User’s Guide

December 2000

set pinhole protocol-select { tcp | udp | icmp | pptp | 

other }

Specifies the type of protocol being redirected.

set pinhole numerical-protocol [ 0 - 65535 ]

If you select 

other

, specifies the number of the protocol you want to 

translate.

set pinhole external-port-start [ 0 - 65535 ]

Specifies the first port number in the range being translated.

set pinhole external-port-end [ 0 - 65535 ]

Specifies the last port number in the range being translated.

set pinhole internal-ip internal-ip

Specifies the IP address of the internal host to which traffic of the 
specified type should be transferred.

set pinhole internal-port internal-port

Specifies the port number your Cayman 3220-H should use when 
forwarding traffic of the specified type. Under most circumstances, 
you would use the same number for the external and internal port.

You can use the following commands to configure basic settings, 
port authentication settings, and peer authentication settings for PPP 
interfaces on your Cayman 3220-H.

Perform the following steps to configure basic PPP settings for a 
virtual circuit.

set PPP module vccn option { on | off }

Enables PPP on a virtual PPP interface. By default, PPP is turned off.