Руководство Пользователя для Netopia 3220-h
Using the Command Line Interface
Cayman 3220-H User’s Guide
4-38
December 2000
set pinhole protocol-select { tcp | udp | icmp | pptp |
other }
Specifies the type of protocol being redirected.
set pinhole numerical-protocol [ 0 - 65535 ]
If you select
other
, specifies the number of the protocol you want to
translate.
set pinhole external-port-start [ 0 - 65535 ]
Specifies the first port number in the range being translated.
set pinhole external-port-end [ 0 - 65535 ]
Specifies the last port number in the range being translated.
set pinhole internal-ip internal-ip
Specifies the IP address of the internal host to which traffic of the
specified type should be transferred.
specified type should be transferred.
set pinhole internal-port internal-port
Specifies the port number your Cayman 3220-H should use when
forwarding traffic of the specified type. Under most circumstances,
you would use the same number for the external and internal port.
forwarding traffic of the specified type. Under most circumstances,
you would use the same number for the external and internal port.
PPP Settings
You can use the following commands to configure basic settings,
port authentication settings, and peer authentication settings for PPP
interfaces on your Cayman 3220-H.
port authentication settings, and peer authentication settings for PPP
interfaces on your Cayman 3220-H.
Basic PPP Settings
Perform the following steps to configure basic PPP settings for a
virtual circuit.
virtual circuit.
set PPP module vccn option { on | off }
Enables PPP on a virtual PPP interface. By default, PPP is turned off.