Справочное Руководство для Netopia r6100

The system will reset at the end of a successful file transfer to put the new firmware into effect. While the 
system resets, the LEDs will blink on and off.

Do not manually power down or reset the Netopia R6000 Series while it is automatically resetting or it 
could be damaged.

The Netopia R6000 Series can be configured by downloading a configuration file. The downloaded file 
reconfigures all of the Router’s parameters. 

Configuration files are available from a site maintained by your organization’s network administrator or from 
your local site (see 

 below).

Follow these steps to download a configuration file:

1.

Make sure you have the configuration file on disk and know the path to its location.

2.

Select Send Config to Netopia and press Return. The following dialog box appears:

3.

Select CANCEL to exit without downloading the file, or select CONTINUE to download the file.

If you choose CONTINUE, you will have ten seconds to use your terminal emulation software to initiate an 
XMODEM transfer of the configuration file. If you fail to initiate the transfer in that time, the dialog box will 
disappear and the terminal emulation software will inform you of the transfer’s failure. You can then tr y 
again.

The system will reset at the end of a successful file transfer to put the new configuration into effect.

A file containing a snapshot of the Netopia R6000 Series’s current configuration can be uploaded from the 
router to disk. The file can then be downloaded by a different Netopia R6000 Series to configure its parameters 
(see 

 above). This is useful for configuring a number of routers with identical 

parameters or for creating configuration backup files.

Uploading a file can also be useful for troubleshooting purposes. The uploaded configuration file can be tested 
on a different Netopia R6000 Series by Netopia or your network administrator.

The procedure below applies whether you are using the console or the WAN inter face. To upload a configuration 
file:

1.

Decide on a name for the file and a path for saving it.

            +--------------------------------------------------------------------+
            +--------------------------------------------------------------------+
            |                                                                    |
            | Do you want to send a saved configuration to your Netopia?         |
            | If so, when you hit Return/Enter on the CONTINUE button, you will  |
            | have 10 seconds to begin the transfer from your terminal program.  |
            |                                                                    |
            |              CANCEL                          CONTINUE              |
            |                                                                    |
            +--------------------------------------------------------------------+