Справочник Пользователя для Netopia r9100

This section may be all you need to do to configure your Netopia R9100 Ethernet Router to connect to the 
Internet.

Your Netopia R9100 Ethernet Router comes preconfigured with the ability to accept an IP address dynamically 
assigned by your ISP. To do this, it acts as a Dynamic Host Configuration Protocol client to your ISP's DHCP 
ser ver. This means that each time you power the Router on when it is connected to the Internet connection line, 
it configures itself with IP address settings without any input on your par t. If your ISP suppor ts this method, skip 
these instructions and go to 

 You don’t need to do anything 

else. This is the true Plug-and-Play solution.

Some ISPs may not be running a DHCP ser ver. In this case, they may simply assign your router a Static IP 
Address and will supply you with several values for you to enter into the Router. The ISP will provide the values 
shown below: 

(You can record these values; print this page and use the spaces above.)

If your ISP assigns your Router a Static IP address, do the following:

1.

From the computer connected to your router, as described in the section 

, open a Telnet session to 192.168.1.1 to bring up the Main Menu.

If you don't know how to do this, see 

.

Alternatively, you can connect the console cable and open a direct serial console connection, using a 
terminal emulator program. See 

Local WAN IP Address

Local WAN IP Mask

Default IP Gateway

Domain Name

Primar y Domain Name Ser ver

Secondar y Domain Name Ser ver