Руководство Пользователя для Allworx 9202
Phone Guide - 9202
Congratulations! You’re the proud new owner of an Allworx
®
9202 VoIP phone. This phone will make it easy for
you to place and receive calls when using the Allworx System.
1 Getting
Started
1.1 What is in the box?
Check out the contents of the box your phone came in. You should have:
• Allworx 9202 phone
• Power supply
• Handset with cord
• Phone Functions Reference Card
• Power supply
• Handset with cord
• Phone Functions Reference Card
Not included, but also needed:
• Ethernet cable to connect the phone to the network
1.2 Connecting the Phone
We have taken all the challenge out of connecting your phone properly. Follow these steps to connect (see the
figure below):
figure below):
1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.
2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end
into your Ethernet jack on the wall.
WARNING: Do not connect to an analog phone line.
3. A computer may be connected to the network through the phone’s Computer jack.
4. Connect the power cable into the phone, and then plug the other end into an outlet. It’s a good idea to
use a surge protector.
5. Thread cables through the strain relief guide.
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved.
Revised: May 28, 2008
Page 1