Руководство Пользователя для Allworx 9202

 

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com 

© 2008 Allworx. All rights reserved. 

Revised: May 28, 2008 

 

Page 3 

2 Adjusting 

Your 

Phone 

2.1  Setup for Desktop  

You must set up the support arm on the back of the Allworx 9202 phone so that it is easy to use and easy to 
read the screen.  

1.  Grasp the phone with one hand and grasp the wall-mount base with the other hand.  

2.  Depress the two tabs on either side of the wall-mount base.  

3.  While holding the phone upright, swing the base out until the support arms are released.  

4.  Locate the slots on the back of the phone in the middle on each side.   

5.  Grasp each support arm at the same time and gently insert them into the slots until they snap in. 

2.2 Volume  

The volume of the incoming ring, handset speaker, base speaker, and the headset is adjustable. 

To adjust the Volume:  

•  Press the VOLUME bar on the left (decrease) or right (increase) to adjust the incoming ring for desired 

audio level.  Do not lift the handset.  

•  To adjust the handset volume, lift the handset and then press the VOLUME bar on the left (decrease) 

or right (increase) for desired audio level.  

•  To adjust the base speaker volume, press the VOLUME bar on the left (decrease) or right (increase) for 

desired audio level while the speaker is in use.  

•  The screen shows the device for which you are adjusting the volume.