Инструкции По Установке для Enterasys mrx
Page 3-4
INSTALLATION
Figure 3-3. Installing the HUB in the Rack
3.3.2 Wall Mounting the HUB
The HUB can be wall mounted in either of two positions. Select one
of the following procedures to provide the desired wall mounting
orientation.
of the following procedures to provide the desired wall mounting
orientation.
Flat Mounting
When the HUB is flat-mounted on a wall surface, it must be installed
with the cable connections facing down. Refer to Figure 3-4 and
perform the following steps to install the HUB as a wall mounted
device.
When the HUB is flat-mounted on a wall surface, it must be installed
with the cable connections facing down. Refer to Figure 3-4 and
perform the following steps to install the HUB as a wall mounted
device.
1.
Remove the four cover screws (two from each side) located along
the bottom edges of each end of the HUB.
the bottom edges of each end of the HUB.
2.
Using the four cover screws (removed in step 1), attach one wall
mounting bracket to each end of the HUB. The bracket should be
flush with the bottom of the HUB.
mounting bracket to each end of the HUB. The bracket should be
flush with the bottom of the HUB.