Справочник Пользователя для Crown XLS 602
XLS Series Power Amplifi ers
Operation Manual
page 7
3 Setup
3.7 Wire Your System
3.7.1 Stereo Mode
Typical input and output wiring is shown in
Figure 3.6.
Figure 3.6.
INPUTS: Connect input wiring for both
channels.
channels.
OUTPUTS: Maintain proper polarity (+/-) on
output connectors.
output connectors.
Connect Channel 1 positive (+) speaker load
to Channel 1 positive (red) terminal of amp;
repeat for negative (-). Repeat Channel 2 wiring
as for Channel 1.
to Channel 1 positive (red) terminal of amp;
repeat for negative (-). Repeat Channel 2 wiring
as for Channel 1.
3.7.2 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 3.7.
Figure 3.7.
INPUTS: Use a custom “Y” adapter cable,
wired to split the signal and invert the polarity
for the Channel 2 amplifi er input as shown in
Figure 3.8. We recommend you label the ends
of the Y adapter to help make sure to connect
the correct end to each amplifi er input.
wired to split the signal and invert the polarity
for the Channel 2 amplifi er input as shown in
Figure 3.8. We recommend you label the ends
of the Y adapter to help make sure to connect
the correct end to each amplifi er input.
Connect the Y adapter between the signal
source and each amplifi er input.
source and each amplifi er input.
NOTE: Crown provides a reference of wiring
pin assignments for commonly used connector
types in the Crown Amplifi er Application Guide
(Section 1.21.) available at www.crownaudio.
pin assignments for commonly used connector
types in the Crown Amplifi er Application Guide
(Section 1.21.) available at www.crownaudio.
OUTPUTS: Connect the speaker across the red
binding post of each channel. Do not use the
black binding posts when the amp is being
operated in Bridge-Mono mode.
binding post of each channel. Do not use the
black binding posts when the amp is being
operated in Bridge-Mono mode.
NOTE: The Channel 1 and 2 level con-
trols MUST be set to identical settings
when operating the XLS amplifi er in
Bridge-Mono mode.
trols MUST be set to identical settings
when operating the XLS amplifi er in
Bridge-Mono mode.
120V
110V
120V
110V
Figure 3.6. System Wiring, Stereo Mode
Figure 3.7. System Wiring, Bridge-Mono Mode
Figure 3.8. Custom Input Cable for Bridge-Mono Mode