Справочник Пользователя для Jet dc-1100a

 

13

 All electrical connections must 
be done by a qualified 

electrician.  All adjustments or repairs must be 
done with the dust collector disconnected from 
the power source, unplugged.  Failure to comply 
may result in serious injury! 

The DC-1100A/RC and DC-1100C/RC dust collectors 
are rated at 115/230V, Prewired 115V.  Use a plug 
and outlet rated at least 20 amps.  The circuit for the 
machine should also be protected by at least a 20 
amp circuit breaker or fuse.  Keep in mind that a 
circuit being used by other machines, tools, lights, 
heaters, etc. at the same time will add to the 
electrical load.  

A dedicated circuit to the dust collector will give you 
the best results since dust collectors are generally 
used at the same time other tools are running. 

Before hooking up to the power source, make sure 
that the switch is in the off position. 

 

 
Before hooking up to the power source, make sure 
that the switch is in the off position. 

Turn the DC-1100A and DC-1100C dust collectors on 
by pressing the Start  button mounted next to the 
motor.  Press the Stop  button to turn off the dust 
collector. 

The DC-1100RC dust collectors can be controlled 
from the control panel mounted on the side of the 
motor (Figure 9) or from a remote control unit (Figure 
10). 

To start the dust collector, press the ON button. If the 
remote control unit (Figure 10) is used, aim it at the 
control panel (Figure 9). The machine will remain 
running until the OFF button is pressed. The digital 
readout will always display 00 while running. 

Once the machine is running, press the TIME button 
to activate the timer. Each time the button is pressed 
and released, the run time is incremented on the 
digital display by one minute and can be set up to 99 
minutes. If the TIME button is pressed and held, the 

time will scroll up to 99 minutes, then start again at 
00. Release the button when the desired set time is 
reached. The dust collector will run for the amount of 
time displayed on the digital display. If you scroll past 
99 and release the button at 10, for example, the 
machine will run for ten minutes, not 110 minutes. 

If the OFF button is pressed while machine is running 
with the timer engaged, the machine turns off and the 
timer is disengaged, i.e., when the machine is 
restarted, the timer must be reset.