Инструкции По Установке для IQinVision iqm30ne-b5
4. To ensure the gasket is sealed gently pull back on the
Ethernet cable as shown in Figure 8.3 before mounting
the enclosure to the wall or ceiling.
the enclosure to the wall or ceiling.
5. Attach the enclosure to the wall or ceiling by tightening
the four screws with sealing washers (Figure 8.4).
NOTE: Be sure to use the supplied screws and
sealing washers. Alternative washers will not seal
the enclosure from moisture. Extra sealing
washers are supplied.
Mounting to masonry or other durable surface wall,
ceiling or overhang with cables routing along the wall
or ceiling for side conduit installation.
ceiling or overhang with cables routing along the wall
or ceiling for side conduit installation.
1. Position the supplied mounting template on the
surface in the location where the camera will be installed.
Trace and drill the mounting holes and the cable pass through hole as indicated.
Trace and drill the mounting holes and the cable pass through hole as indicated.
2. Remove the conduit plug from the enclosure. Install a ½” (12.7mm) threaded
conduit connector (not supplied) into the conduit hole on the enclosure.
NOTE: To ensure proper weatherization on the conduit entry, properly seal
the conduit threads with silicon.
3. Pull the Ethernet cable through the conduit and then through the enclosure. Pull
enough cable through the conduit to attach an RJ-45 network connector, and to
allow the network connector to plug into the Ethernet socket.
allow the network connector to plug into the Ethernet socket.
4. Attach the enclosure to the wall or ceiling by tightening the four screws with
sealing washers.
NOTE: Be sure to use the supplied screws and sealing washers. Alternative
washers will not seal the enclosure from moisture. Extra sealing washers
are supplied.
NOTE: When installing the Alliance-mx onto a ceiling tile, use hardware
designed to secure the camera assembly to this surface, and ensure the ceiling
tile material is secure.
In addition, follow local regulations and laws that may have specific requirements
governing the installation of security equipment on a ceiling tile surface. IQinVision
also strongly recommends the use of a ceiling tile brace and other mounting
hardware designed to secure the Alliance-mx to the ceiling frame infrastructure.
governing the installation of security equipment on a ceiling tile surface. IQinVision
also strongly recommends the use of a ceiling tile brace and other mounting
hardware designed to secure the Alliance-mx to the ceiling frame infrastructure.
7
Figure 8.3
Figure 8.4