Справочник Пользователя для JVC GR-DVP9

Master Page: Right-Heading0

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, 
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery 
pack, AC Power Adapter/Charger, etc.) and wait a few minutes; and then re-connect it and proceed as usual 
from the beginning.

1. No power is supplied.

1. • The power is not connected 

properly.

• The battery is dead.
• The LCD monitor is not open 

fully or the viewfinder is not 
pulled out when recording.

1. • Connect the AC Power 

Adapter/Charger securely. 
(

• Replace the dead battery 

with a fully charged one. 
(

墌 pg. 10, 11)

• Open the LCD monitor fully 

or pull out the viewfinder.

2. Recording cannot be 

performed.

2. • The Power Switch is set to 

“P” or “OFF”.

— For Video Recording —
• The tape’s erase protection 

tab is set to “SAVE”.

• The VIDEO/MEMORY 

Switch is set to “MEMORY”.

• “TAPE END” appears.
• The cassette holder cover is 

open.

— For D.S.C. Recording —
• The VIDEO/MEMORY 

Switch is set to “VIDEO”.

2. • Set the Power Switch to “A” 

or “M”. (

墌 pg. 17, 23)

— For Video Recording —
• Set the tape’s erase 

protection tab to “REC”. 
(

• Set the VIDEO/MEMORY 

Switch to “VIDEO”.

• Replace with new cassette. 

• Close the cassette holder 

cover.

— For D.S.C. Recording —
• Set the VIDEO/MEMORY 

Switch to “MEMORY”.

3. When shooting a subject 

illuminated by bright light, 
vertical lines appear.

3. • This is a result of exceedingly 

high contrast, and is not a 
malfunction.

—

4. When the screen is under 

direct sunlight during shooting, 
the screen becomes red or 
black for an instant.

4. • This is not a malfunction.

—

5. During recording, the date/ 

time does not appear.

5. • “DATE/TIME” is set to “OFF”. 5. • Set “DATE/TIME” to “ON”. 

墌 pg. 31, 38)

6. During recording, sound 

cannot be heard.

6. • The optional headphones are 

not connected to the 
headphones connector.

6. • Connect the optional 

headphones to the 
headphone connector. 
(

GR-DVP9-8PAL.book  Page 65  Friday, February 7, 2003  12:35 PM