Руководство Пользователя для LXE mx3
238
5380SF 2D Imager
Integrated Scanner Programming Guide
E-SW-SCANNERPG-L
Intermessage Delay
Parameter Default Value:
0 ms / Range: Min: 0 ms / Max: 495 ms
Figure 4-6 Intermessage Delay Example
Intermessage Delay
An intermessage delay of up to 495 milliseconds may be placed between the transmission of each
scan transmission. The imager can be programmed up to 99 steps (of 5 ms each) for a range between
0 and 495 ms.
scan transmission. The imager can be programmed up to 99 steps (of 5 ms each) for a range between
0 and 495 ms.
Scan the Intermessage Delay barcode, then set the steps by scanning up to 2 digits in a row using
the symbols on the “Keypad Alphanumeric Symbols” page at the end of this chapter, and scan Save.
If you make an error while scanning the digits (before scanning Save), scan the Discard barcode, scan
the Interfunction Delay barcode, scan the correct digits, and then scan the Save barcode again.
the symbols on the “Keypad Alphanumeric Symbols” page at the end of this chapter, and scan Save.
If you make an error while scanning the digits (before scanning Save), scan the Discard barcode, scan
the Interfunction Delay barcode, scan the correct digits, and then scan the Save barcode again.
To remove an Intermessage delay, scan the Intermessage Delay barcode, then scan a zero using the
number symbols on the “Symbols 0-9” page at the end of this chapter, and scan Save.
number symbols on the “Symbols 0-9” page at the end of this chapter, and scan Save.