Руководство Пользователя для LXE mx3
236
5380SF 2D Imager
Integrated Scanner Programming Guide
E-SW-SCANNERPG-L
User-Specified Intercharacter Delay
Parameter Default Value:
0 ms / Range: Min: 0 ms / Max: 495 ms
Delay Length
An intercharacter delay of up to 495 milliseconds may be placed after the transmission of a particular
character of scanned data. The imager can be programmed up to 99 steps (of 5 ms each) for a range
between 0 and 495 ms.
character of scanned data. The imager can be programmed up to 99 steps (of 5 ms each) for a range
between 0 and 495 ms.
Scan the Delay Length barcode, then set the steps by scanning up to 2 digits in a row using the
symbols on the “Keypad Alphanumeric Symbols” page at the end of this chapter, and scan Save. If
you make an error while scanning the digits (before scanning Save), scan the Discard barcode, scan
the Delay Length barcode, scan the correct digits, and then scan the Save barcode again.
symbols on the “Keypad Alphanumeric Symbols” page at the end of this chapter, and scan Save. If
you make an error while scanning the digits (before scanning Save), scan the Discard barcode, scan
the Delay Length barcode, scan the correct digits, and then scan the Save barcode again.
Character to Trigger Delay
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for the ASCII
character that will trigger the delay. Two digit hex values are listed in the section titled “ASCII
Conversion Chart” at the end of this chapter.
character that will trigger the delay. Two digit hex values are listed in the section titled “ASCII
Conversion Chart” at the end of this chapter.
To remove an Intercharacter delay, scan the Delay Length barcode, then scan a zero using the
number symbols on the “Symbols 0-9” page at the end of this chapter, and scan Save.
number symbols on the “Symbols 0-9” page at the end of this chapter, and scan Save.