Руководство Пользователя для LXE mx3
76
Symbol Barcodes
Integrated Scanner Programming Guide
E-SW-SCANNERPG-L
Time-out Between Decodes, Different Symbols
Scanner:
SE2223 in scan stand mode
Parameter Default Value:
0.0 Seconds
Use this parameter to prevent the beeper from beeping when a different symbol appears in the
scanner's field of view before the timeout period between decodes expires.
scanner's field of view before the timeout period between decodes expires.
To begin setting differing symbol timeout values, scan this barcode:
Timeout / Decodes - Diff Symbol
Using the "Keypad Number Symbols" section at the end of this chapter, scan two numeric barcodes
that represent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9
seconds.
that represent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9
seconds.
If you wish to change your number selection, scan Cancel on the “Keypad Number Symbols” page.
Time-out Between Decodes, Same Symbol
Scanner:
2223 1524 1224 1223 955 923 824
Parameter Default Value:
SE2223: 0.6 second
Others: 1.0 second
Use this parameter to prevent the beeper from continuously beeping when a symbol is left in the
scanner's field of view.
scanner's field of view.
To begin setting differing symbol timeout values, scan this barcode:
Timeout / Decodes - Same
Using the "Keypad Number Symbols" section at the end of this chapter, scan two numeric barcodes
that represent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9
seconds. Single digit values must be predefined by a leading zero. For example, to set a timout of 0.5
seconds, scan the Timeout/Decodes – Same barcode, then scan the number 0 and 5 barcodes.
that represent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9
seconds. Single digit values must be predefined by a leading zero. For example, to set a timout of 0.5
seconds, scan the Timeout/Decodes – Same barcode, then scan the number 0 and 5 barcodes.
If you wish to change your number selection, scan Cancel on the “Keypad Number Symbols” page.