Краткое Руководство По Установке для Ricoh ap204
Windows 95/98 Configuration
8
1
Configuring Windows 95/98
Preparing to Print
The network must be configured as described below.
Configuring the Printer
Configure your printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is
• Confirm that the TCP/IP protocol is set to be active. (The factory default is
Active)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information on how to make above settings, refer to the Operating
Instructions on your printer.
If DHCP is used to assign IP addresses, refer to ... P.86 “When to Use DHCP”.
Instructions on your printer.
If DHCP is used to assign IP addresses, refer to ... P.86 “When to Use DHCP”.
Note
❒ After setting the IP address, use the PING command to confirm that it has
been set correctly.
A
Click
[Start]
, point to
[Programs]
, and then click
[MS-DOS Prompt]
.
B
Input the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured properly, the following message ap-
pears.
pears.
TCP/IP
Windows 95/98
Basic Procedure
Installing the Multi Direct Print
Configuring Windows environment
Assigning the IP address
Installing the printer driver
Changing the port