Краткое Руководство По Установке для Ricoh ap204
Appendix
86
6
When print PostScript from Windows
When print PostScript from Windows, refer to operationg instructions attached
to PostScript kit, and configure to use a network interface board with printer
driver.
to PostScript kit, and configure to use a network interface board with printer
driver.
When print it with NetWare
Configuration of form feed
Please do not configure of form feed on NetWare. You do not need to configure
on NetWare in order to control newpage with printer driver of Windows. There
is the case that cannot print it justly when you configure.
If you want to do not do form feed, configure according to OS using it as follows.
• In case of Windows 3.1x, avoid a check of
on NetWare in order to control newpage with printer driver of Windows. There
is the case that cannot print it justly when you configure.
If you want to do not do form feed, configure according to OS using it as follows.
• In case of Windows 3.1x, avoid a check of
[Form feed]
in configuration of net-
work driver.
• In case of Windows95/98, you avoid a check of
[Form feed]
with
[Printer Set-
tings]
tab of property of printer.
Configuration of banner page
Please do not configure of banner page on NetWare.
If you want to do not add banner page, configure according to OS using it as fol-
lows.
• In case of Windows 3.1x, avoid a check of
If you want to do not add banner page, configure according to OS using it as fol-
lows.
• In case of Windows 3.1x, avoid a check of
[Enable banner]
in configuration of
network driver.
• In case of Windows95/98, you avoid a check of
[Enable banner]
with
[Printer
Settings]
tab of property of printer.
Printing after Resetting the Printer
After resetting the remote printer, it will be cut off from the print server for about
30-40 seconds before connecting again. During this interval print jobs may be ac-
cepted, but they will not be printed. This is a NetWare feature.
When using the printer as a remote printer, wait about 2 minutes after resetting
the printer before attempting to print.
30-40 seconds before connecting again. During this interval print jobs may be ac-
cepted, but they will not be printed. This is a NetWare feature.
When using the printer as a remote printer, wait about 2 minutes after resetting
the printer before attempting to print.
When to Use DHCP
The following points are important when using DHCP (Dynamic Host Configu-
ration Protocol).
ration Protocol).