Справочник Пользователя для Haier tw22

Positioning the appliance in the desired

location.The back should rest against the wall

behind it,and the sides,along the adjacent cabi-

nets or wall.The dishwasher is equipped with

water supply and drain hoses that can be po-

sitioned to the right or the left to facilitate proper

installation.

Once the appliance is positioned,adjust the

feet (screwing them in or out) to adjust the

dishwasher,making it level.In any case,the ap-

pliance should not be inclined more than 2

.

If the appliance is level,it will help ensure

proper performance.

Connect the cold water supply hose to a

threaded 3/4(gas)connector ,inserting the

small filter supplied with the dishwasher and

making sure that it is fastened tightly in place

(see figure1/A).SOme models have an

"Acquablock" water supply pipe (see fig.1/B)

with filter in the threaded inlet.

If the water pipes are new or have not been

used for an extended period of time,let the

water run to make sure that the water is clear

and free of impurities.If this precaution is not

taken,there is a risk that the water inlet can

get blocked and damage the appliance.

Insert the drain hose into a drain pipe with a

minimum diameter of 4cm,Or let it run into

the sink,making sure to avoid bending or

crimping it.Use the special plastic support that

comes with the appliance (see fig .C).The free

end of the hose must be at a height between

40 and 100 cm and must not be immersed in

water.

After making sure that the voltage and

frequency values for the current in the home

correspond to those on the rating plate

(located on the stainless steel inner door of

the appliance) and that the electrical system

is sized for the maximum voltage on the rat-

ing plate,insert the plug into an electrical

socket which is earthed properly (the earthing

of the appliance is a safety requirement man-

dated by law).

If the electrical socket to which the appliance

must beconnected is not appropriate for the

plug,replace the plug ,rather than using

adpators or the like as they could cause over-

heating and burns.

The water supply to the appliance can also be

connected to the house's hot water line

(centralised system,heating system),as long as

it does not exceed a temperature of 60

.

In this case,the wash cycle time will be short-

ened by about 15 minutes and the wash effi-

ciency slightly reduced.

The connection must be made to the hot water

line following the same procedures as those

for the connection to the cold water line.

MAX 100 MIN 40

S

ON

OFF

PUL
L

R