Справочник Пользователя для Haier tw22

For best performance and results, the filter as-

sembly must be cleaned.

The filter efficiently removes food particles

from the wash water,allowing it to be recircu-

lated during the cycle.For this reason ,it is a

good idea to remove the larger food particles

trapped in the filter after each wash  cycle by

rinsing the"A"semi-circular filter and cup un-

der running water.To remove the filter

assembly,pull on the cup handle in the upward

direction. The entire filter assembly (made  up

of the "A" semicircular filter and the"B" fine

filter)should be cleaned at least once a month.

To clean the filter and the fine filter,use a clean-

ing brush .Then,reassemble the filter parts as

shown in the figures below and reinsert the

entire aseembly in the dishwasher,positioning

in its seat and pressing downward.

The dishwasher must never be used without

the filters.Improper replacement of the filters

may reduce level of the appliance and dam-

age dishes and utensils.

It may happen that food particle become en-

crusted on the sprayer arms and block the

hole. Check the sprayer arms periodically and

clean them when needed. (see "Close up view

[interior]",letters C-E ).

It may occur that the dishwasher does not

function or does not function properly.Before

calling for assistance,Iet us see what can be

done first:have you forgot to press one of the

buttons or to perfom an essential operation?

Have you checked whether:

- the plug is pushed into  the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

Have you checked whether:

- the water is turned on and the hose is

  connected properly;

- the water supply to the house on and has

  sufficient pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

Have you checked whether:

- the water is turned on and the hose is

  connected properly;

- the water supply to the house on and has

  sufficient pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

Have you checked whether:

- the drain hose is crimped or bent.

Have you checked whether:

- the lid to the salt container is closed properly;

- the rinse aid dosage is correct.

If,despite all these checks,the dishwasher still

does not function and/or the problem persists,

contact the nearest authorised service centre

a n d   p r o v i d e   t h e m   w i t h   t h e   f o l l o w i n g

information:

- the nature of the problem;

- the model type number (Mod...)and the

  serial number (S/N...),which are indicated on

  the plate located on the side of the inner part

  of the door.

Periodically clean the water inlet filter(see fig-

ure 1/A) located on the outlet of the water sup-

ply tap.

After turning off the water tap, unscew the end

of the water supply hose,remove the filter and

clean it carefully under running water.Then,

return the filter to its place and tighten the water

supply hose back into position.