Руководство Пользователя для Nortel 4000
A-59
Appendix A RAC Parameters
Managing Remote Access Concentrators Using Annex Manager
map
controls mapping of DS0s between the T1 Network Interface and the T1 Drop
and Insert Interface, as well as mapping of modems to the T1 Drop and Insert
Interface and the T1 Network Interface.
and Insert Interface, as well as mapping of modems to the T1 Drop and Insert
Interface and the T1 Network Interface.
You can enter a 4-digit number consisting of two parts. The right-hand two digits
control the type of mapping. The left-hand two digits identify the destination
modem, if any, and must be 00 if there is no destination modem. You can enter:
control the type of mapping. The left-hand two digits identify the destination
modem, if any, and must be 00 if there is no destination modem. You can enter:
•
01
to mark a DS0 as unused. When you use
01
, the next two
digits must be
00
.
•
02
to mark a T1 Network Interface DS0 as mapped to modem
number
nn
, where
nn
represents the two digits that follow.
•
03
to mark a T1 Drop and Insert Interface DS0 as mapped to
modem number
nn
, where
nn
represents the two digits that
follow.
•
04
to mark a T1 Network Interface DS0 as mapped in voice
mode directly to the Drop and Insert Interface. When you use
04
, the next two digits must be
00.
•
05
to mark a T1 Network Interface DS0 as mapped in data
mode directly to the Drop and Insert Interface. When you use
05
, the next two digits must be
00.
map_to_lower
allows a RAC to convert uppercase characters sent from a terminal using CLI
into lowercase characters. This parameter is used for older terminals that do not
support lowercase characters.
into lowercase characters. This parameter is used for older terminals that do not
support lowercase characters.
Type
T1 DS0
Values
4-digit number (see combinations above)
Default
02 + a two-digit number equal to the DS0.
Lists
T1_DS0
Type
Async
Values
enabled or disabled
Default
disabled
Lists
Async Port, Command Line Editing