Инструкции По Установке для Nortel 100
29
Installing the BayStack Instant Internet Management Software Version 7.11
Chapter 3
Installing the Instant Internet software
Installing the Instant Internet software
This chapter describes how to install the Instant Internet management software
and configure the Instant Internet unit.
and configure the Instant Internet unit.
Before you begin
Before you install and configure Instant Internet, you should:
•
to determine what additional
preparation is necessary for installing the Instant Internet unit.
•
Install the Instant Internet hardware. Depending on your hardware, refer to
one of the following manuals on the BayStack Instant Internet Software and
Documentation Version 7.11 CD shipped with your Instant Internet unit:
one of the following manuals on the BayStack Instant Internet Software and
Documentation Version 7.11 CD shipped with your Instant Internet unit:
— Setting Up the BayStack Instant Internet 100 Unit
— Setting Up the BayStack Instant Internet 100-S Unit
— Setting Up the BayStack Instant Internet 400 Unit
— Setting Up the BayStack Instant Internet 400-S Unit
Be sure to review the “Installation Checklist” and complete the “Installation
Worksheet” in Chapter 2 of the manual.
Worksheet” in Chapter 2 of the manual.
•
If necessary, make sure that your Ethernet device (for example, a router, a
cable modem, or xDSL modem) or 1-Meg modem is plugged in and has an
active connection to your ISP.
cable modem, or xDSL modem) or 1-Meg modem is plugged in and has an
active connection to your ISP.
Caution:
Before you start the Instant Internet Install program, make sure
that LED 2 on the front panel of the unit is glowing amber.
DO NOT
PROCEED
if LED 2 is not glowing amber.