Инструкции По Установке для Nortel 100
32 Chapter 3 Installing the Instant Internet software
209226-B
Configuring the Instant Internet unit
The first step when installing an Instant Internet unit is to configure the unit for
your network.
your network.
Before you begin, if you have an existing DHCP server and want to continue
using it, you must set up your server according to the information in
using it, you must set up your server according to the information in
.
If you need help entering information in a dialog box, press [F1] for online Help.
Configuring the unit for your network
Before you start the Instant Internet Install program, make sure that LED 2 on the
front panel of the unit is glowing amber.
front panel of the unit is glowing amber.
If you are connecting an Ethernet device (for example, a router, a cable modem, or
xDSL modem) or 1-Meg modem, ensure that the device is plugged in and has an
active connection to your ISP.
xDSL modem) or 1-Meg modem, ensure that the device is plugged in and has an
active connection to your ISP.
Note:
Read through these installation procedures one time before you
attempt to install and configure the Instant Internet unit. Knowing what
is expected during the installation helps the entire process go more
smoothly.
is expected during the installation helps the entire process go more
smoothly.
Caution: DO NOT PROCEED
if LED 2 is not glowing amber. For
more information on interpreting LED indicators, refer to the hardware
guide for your Instant Internet unit.
guide for your Instant Internet unit.